Toro OEM 108-4912 Handle Slider – Right-Hand Chute Adjustment

Keep your Toro single-stage snowblower chute turning smoothly with this genuine Toro OEM 108-4912 Handle-Slider, Right-Hand. This slider is part of the chute control handle assembly and allows you to easily rotate and aim the discharge chute while you clear snow.

• OEM Part Number: 108-4912
• Part Name: Handle-Slider, RH (right-hand chute adjustment slider)
• Application: Upper handle chute control assembly
• Genuine Toro OEM: Correct fit and function for Power Clear and Quick Clear units

Fits These Toro Snowblower Models

Verify your model number from the tag on the unit before ordering.

38458, 38459, 38563, 38567, 38568, 38569, 38576, 38577, 38578, 38583, 38584, 38585, 38586, 38588, 38589, 38743, 38744, 38756, 38757

Related Parts (Frequently Replaced Together)

These parts are all in the same chute control and handle assembly and are good add-ons when the slider is worn or damaged:

• 108-4911 – Handle-Slider, LH (left-hand slider)
• 108-4899 – Track-Slider (rail the handle slides on)
• 108-4907 – Pulley-Slider (pulley the chute cables wrap around)
• 108-4897 – Cable-Chute, Short
• 108-4898 – Cable-Chute, Long
• 108-4931 – Cover-Pulley
• 108-4913 – Trigger (chute lock trigger)
• 108-4908 – Plate-Lock, Chute
• 108-4909 – Bracket-Cable (supports the chute cable)

Additional Recommended Items

• Rotor drive belt (e.g. Toro 108-4921 – check your model & serial number)
• Scraper bar / scraper blade
• Rubber paddles / rotor blades
• 5W-30 winter engine oil
• Spark plug and fuel stabilizer for seasonal tune-up

Installation Tips

• Work on a clean, level surface with the engine off and the spark plug wire disconnected.
• Remove the handle hardware and old slider from the chute control track; note cable routing before disassembly.
• Inspect the track slider (108-4899) and pulley-slider (108-4907) for wear – replace if grooved or cracked.
• Install the new right-hand slider with the original screws and hardware, making sure it moves freely along the track.
• Confirm the chute cables are seated correctly in the pulley and guides, then test full left/right chute rotation before use.
• Do not overtighten the mounting screws – overtightening can crack the plastic slider or track.

Not sure if this is the right part?
Contact us with your Toro model and serial number and we’ll verify the correct part before you order.